Filter
Top Products
48
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Editing Features
3, 4, 5PAUSE
3, 4PLAY
6STOP
High quality digital-to-digital copying can be
accomplished if both Palmcorders incorpo-
rate the DV Input/Output (i.LINK) Connec-
tor (DV Interface cable (i.LINK) is not
supplied).
1 Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
2 Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
3 Press (PLAY) on the source
Palmcorder. When the tape reaches
the point from which you want to start
dubbing, press
(PAUSE).
4 Hold down (REC) and press
(PLAY) on the target (recording)
Palmcorder.
Press
(PAUSE) to pause the tape at
the starting point of the dub.
5 Simultaneously, press (PAUSE) on
both units to begin dubbing.
6 Press (STOP) on the recording
unit, and then press (STOP) on the
playing unit to end dubbing.
• When two Palmcorders are used for
dubbing, it is recommended that the
Remote Control (Optional) VCR1 or VCR2
setting be used to avoid improper-
operation.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
Source (Playing)
Palmcorder
Recording
Palmcorder
DV Interface
Cable (i.LINK)
(optional)
DV Input/Output
(i.LINK) Connector
Copying from Digital
Equipment (dubbing)
Note
Before you begin
• Connect both Palmcorders to their
power sources.
• Connect the two Palmcorders using the
DV Interface cable (i.LINK)
(4-pin to 4-pin).
• Turn both Palmcorders ON.
4REC
3, 4
PLAY
4REC
3, 4, 5
PAUSE
6STOP
Optional
DV203.p 45-48.p65 03/01/20, 14:5648