Filter
Top Products
49
Card Features
Card Features
You can record still images to a Memory Card.
1 Set POWER to M-CARD.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
M-CARD position.
•“PLAY: PUSH PLAY KEY” is
displayed for 10 seconds. (p. 51)
2 Press MENU to display CARD SETUP
menu, then press JOG KEY to select
NORMAL or FINE .
• Press MENU to exit this menu.
3 Press PHOTOSHOT to record an
image.
• The PhotoShot image is recorded to
the Memory Card.
• When SHTR EFFECT is set to ON
(Menu OSD: p. 109), still pictures are
recorded with a visual shutter effect
and click sound. If set to OFF, the still
image will be displayed only.
1POWER
2JOG KEY
3PHOTOSHOT
• While “PROCESSING” is displayed, DO
NOT turn off the Palmcorder or unplug
the AC Adaptor (supplied) because this
will cause irreversible damage to the
memory.
• When recording DV Tape playback output
to the Memory Card, only NORMAL mode
is available. (p. 50)
Before you begin
• Connect the Palmcorder to a power
source. (pp. 15, 16)
• Set POWER to OFF before inserting a
Memory Card. (p. 14)
Card PhotoShot
• When using an M-CARD, DV Output will
not function.
Warning
Warning
Image Resolution and Capacity
(Supplied 8MB Memory Card)
REC
Mode
FINE
NORMAL
Image
Resolution
1280 x 960
640 x 480
Capacity
Approx. 30 images
Approx. 70 images
• The number of images given for each
mode applies when all images are taken
in same mode.
• You can change recording modes at any
time before capturing an image.
• The number of images that can be
captured may differ depending on the
subject. After capturing an image, the
number may not decrease, or it may
decrease by two. This is normal.
Note
• 1280 x 960 PhotoShot image is
interpolated from 640 x 480 image.
• Some artifacting, softened edges or
picture noise may occur in Fine (1280 x
960) Mode.
• PhotoShot capture time for Fine Mode
(1280 x 960) is approximately 10 seconds,
and for Normal Mode (640 x 480) is
approx. 5 seconds.
2MENU
DV203.p 49-52.p65 03/01/20, 14:5649