Filter
Top Products
95
For Your Information
Replacing Clock Battery
The clock battery is pre-installed. Follow the steps below if replacement becomes
necessary.
Replace battery with Panasonic or Newsun type CR2025 only. Use of another battery
may present a risk of fire or explosion.
Caution: battery may explode if mistreated. Dispose of used battery properly. Keep
away from children. Do not recharge, disassemble or dispose of in a fire.
WARNING
Clock Battery
1 While pinching the 2 tabs, pull
Battery Tray out.
2 Bend middle tab out and remove
Battery.
3 Snap new Battery ( + mark down)
into Battery Tray.
• Do not reverse the polarity.
4 Insert Battery Tray so the triangle
marks meet.
Note
• Keep Battery out of children’s reach.
Swallowing it may be harmful.
• Improper installation, discharge, or
missing battery causes “CLOCK
BATTERY” to appear.
• Battery life is approximately 5 years.
• Set POWER to OFF or disconnect the
Palmcorder from a power source when
replacing the clock battery.
1
4
Before you begin
• Set POWER to OFF or disconnect the
Palmcorder from a power source.
Notes On Operations
DV203.P 92-96.p65 03/01/20, 14:5895