Panasonic PV-DV203 Camcorder User Manual


 
73
PC Connection
Using Tape Image Data
Before you begin
Insert a recorded Tape. (p. 12)
Make Palmcorder-PC connections.
(p. 72)
Turn your PC on.
Set Palmcorder POWER to VCR.
Run the Software after the DV
Interface Cable (i.LINK) has been
connected to the Palmcorder.
1 Repeat steps 1~4 on page 62 to
run the PHOTOVU/MPEG4 Movie
Messenger System.
When the DV Interface Cable (i.LINK)
is connected, the input display will
automatically become DV. If it is not
DV, please confirm the connection.
Then, close and restart the software.
When using Windows XP, Windows
Movie Maker may open
automatically. If so, close Windows
Movie Maker and Movie
Messenger, and open Movie
Messenger again.
2 Click (PLAY) button on PC screen
to playback the DV tape.
Please use the LCD monitor on the
Palmcorder or PC screen for
confirmation.
By connecting the Palmcorder and PC with
the DV Interface Cable (i.LINK), you can
transfer Motion images and Still images
saved on the DV Tape directly to your PC.
To capture Motion images
3 Click on [Normal] .
4 Click on [Movie Capture] at the
point you wish to capture a Motion
image. Click on [STOP] to end capture.
The image is transferred to the PC in
real time.
The maximum capture time is approx.
3 minutes.
When capturing data containing
changes between 12 bit and 16 bit
and/or between SP and LP mode, a
separate file will be made for each
mode.
Please refer to pages 64~71 for other
functions.
If PHOTOVU/MPEG4 Movie Messenger
System does not work, please refer to
note on page 72.
Deactivate your PC ScreenSaver or
this application may shutdown during
image capture.
Note
Note
2PLAY
4Movie
Capture
PHOTOVU/MPEG4 Movie Messenger System (i.LINK)
DV
3Normal
[When selecting Normal]
(Continued on next page.)
STOP
ASet Palmcorder POWER to VCR.
BConnect the Palmcorder to your PC
using the DV Interface Cable
(i.LINK) (not supplied).
CStart up the PHOTOVU/MPEG4
Movie Messenger System.
How to insert the DV Interface
Cable (i.LINK)
AClose the PHOTOVU/MPEG4 Movie
Messenger System.
BRemove the DV Interface Cable
(i.LINK) from the Palmcorder.
CSet Palmcorder POWER to OFF.
How to remove the DV Interface
Cable (i.LINK)
DV203.p 72-74.p65 03/01/20, 14:5773