Filter
Top Products
26
For assistance, please call : 1-800-211-PANA(7262) or
send e -mail to : consumerproducts@panasonic.com
Remote Control (Optional)
You can control any two Panasonic
Palmcorders with one Remote control
(Optional, page 64). In order for the remote
to distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
DATE /
TIME
PHOTO
SHOT
REC /
PAUSE
A.DUB
MENU
STOP /
SET
INDEX
SEARCH
SLOW /
F.A DV
PAUSE /
SEL
SLOW /
F.A DV
REW / PLAY
FF /
- SPKR VOL +
T
W
INDEX
SEARCH
REC
CAMCORDER
CAMERA
DISPLAY
ON TV
COUNTER /
TC
RESET
For VCR 2 :
Press these
buttons at the
same time.
For VCR 1 :
Press these
buttons at the
same time.
Remote Controlling Two
Palmcorders
Optional
Note
1Set the POWER to VCR or CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
2Press MENU to display the VCR or
CAMERA mode menu screen.
3Rotate JOG KEY to select CAMERA
SET-UP in the CAMERA mode menu
screen or VCR PLAY MODE in the
VCR mode menu screen, then press
JOG KEY to display the CAMERA
SET-UP or VCR PLAY MODE menu
screen.
4Rotate JOG KEY to select REMOTE ,
and then press JOG KEY to select
VCR 2. (See pages 16, 17). Leave the
other Palmcorder set to VCR1.
5Set the Remote Control (Optional,
page 64) to VCR 1 or VCR 2 to
correspond with the Palmcorder you
wish to control. (See above left.)
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), “CHECK REMOTE MODE
(REMOTE)” will appear.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
Remote Control (Optional)
A
Replace battery with Panasonic PART NO. VSBW0004 (CR2025)
only. Use of another battery may present a risk of fire or explosion.
Caution: battery may explode if mistreated. Dispose of used battery
properly. Keep away from children. Do not recharge, disassemble or
dispose of in fire.
1Insert a slender pointed object, such as the tip of a ball-
point pen into the slot so that it fits into the hole (as shown
A). Then, while sliding to the right, pull the Battery Tray
out with your fingernail.
2Insert the battery into the Battery Tray with the + mark
facing down.
Do not reverse the polarity.
3Insert the Battery Tray.
+
Replace the Battery
Optional
B
201_401.25-27.p65 01/01/18, 17:0826