Filter
Top Products
52
For assistance, please call : 1-800-211-PANA(7262) or
send e -mail to : consumerproducts@panasonic.com
Special Features
Special Features
DATE /
TIME
PHOTO
SHOT
REC /
PAUSE
A.DUB
MENU
STOP /
SET
INDEX
SEARCH
SLOW /
F.A DV
PAUSE /
SEL
SLOW /
F.A DV
REW / PLAY
FF /
- SPKR VOL +
T
W
INDEX
SEARCH
REC
CAMCORDER
CAMERA
DISPLAY
ON TV
COUNTER /
TC
RESET
3, 4
PLAY
Button
3, 4, 5
PAUSE Button
3, 4
PLAY Button
6STOP
Button
4REC
Button
High quality digital-to-digital copying can
be accomplished if both Palmcorders
incorporate the DV Input/Output (i.LINK)
Connector (DV interface cable (i.LINK) is
not supplied).
1Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
2Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
3Press PLAY on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press PAUSE.
4Hold down REC and press PLAY on
the target (recording) Palmcorder or on
the remote control (optional, page 64).
Press PAUSE to pause the tape at the
starting point of the dub.
5Simultaneously, press PAUSE on
both units to begin dubbing.
6Press STOP on the recording
unit, and then press STOP on the
playing unit to end dubbing.
• When two Palmcorders are used for
dubbing, it is recommended that the
remote control VCR1 or VCR2 setting be
used to avoid improper-operation.
• When two Palmcorders are connected
using the DV interface cable (i.LINK) (not
supplied), a Video Editing Controller
cannot be used.
• Do not connect both an S-Video Cable or
A/V Cable and a DV Interface Cable
(i.LINK).
CAUTION:
Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
Source (Playing)
Palmcorder
Recording
Palmcorder
DV Interface Cable (i.LINK)
(optional)
DV Input/Output
Connector
Copying from Digital
Equipment (dubbing)
Optional
Note
4REC
Button
3, 4, 5
PAUSE
Button
Before you begin
• Connect both Palmcorders to their
power sources.
• Connect the two Palmcorders using the
DV interface cable (i.LINK)
(4-pin to 4-pin).
• Turn both Palmcorders ON.
201_401.49-52.p65 01/01/18, 17:0852