Filter
Top Products
67
For Your Information
For Your Information
Notes On Operations
Cleaning EVF (Electronic Viewfinder)
1 Slide the Viewfinder backward to its fully
expanded position and then tilt it upward.
2 Remove the 2 screws from the EVF Eyepiece
with a screwdriver (+).
3 Turn the Eyepiece counterclockwise 1/8 of a
turn.
4 Pull the Eyepiece free. Remove any lint or dust
particles with a soft clean cloth being careful not
to scratch the glass surfaces.
5 To re-install the Eyepiece
Line up the marks on the Eyepiece with the
grooves inside the EVF shaft and attach. Turn it
clockwise 1/8 of a turn to lock in place.
6 Replace the EVF Eyepiece screws and tighten
with a screwdriver.
• If you lose an EVF Eyepiece screw, order Part
No.XQN2+BJ5FXK.
Notes On Operations
COLOR TINT
MIXTURE
PALMCORDER
SETTINGS
Bluish
Whitish
Yellowish
Reddish
ARTIFICIAL LIGHT SOURCENATURAL LIGHT
CONDITIONS
“OUTDOOR”
- - - - - - - - - - - - -
- - -
• Color television
• Fluorescent lamp (Daylight)
• Camera flash bulb
• Blue lamp for photography
• Fluorescent lamp (White)
• Normal flash bulb
• Fluorescent lamp (Off-white)
• Tungsten lamp for
photography
• Halogen lamp
• Iodine lamp
• Tungsten lamp
• Acetylene lamp
• Kerosene lamp
• Candlelight
KELVIN COLOR
TEMPERATURE
• Fair weather, blue sky
• Slightly cloudy sky
• Cloudy or rainy sky
• Sunlight in clear weather at
midday
• Average sunlight in clear weather
• Sunlight 2 hours after sunrise
and before sunset
• Sunlight 40 min. after sunrise
and before sunset
• Sunlight 30 min. after sunrise
and before sunset
• Sunlight 20 min. after sunrise
and before sunset
(Amber Filter
Range)
— 10,000
— 8,000
— 7,000
— 6,500
— 6,000
— 5,500
— 5,000
— 4,500
— 4,000
— 3,500
— 3,200
— 2,800
— 2,000
“AUTO”
Approximate Brightness Values
Your Palmcorder has been designed for normal scene illumination of 150 footcandles
(1500 lx). However, the Palmcorder may be used at F1:1.6, if illumination is more than
0.5 footcandles (5 lx).
The table below shows the color temperature for reference.
1 Turn the Eyepiece
counterclockwise 1/8 of a turn.
2 Pull the Eyepiece free.
Remove any lint or dust
particles with a soft, clean
cloth being careful not to
scratch the glass surfaces.
3 To re-install the Eyepiece
Line up the marks on the
Eyepiece with the grooves
inside the EVF shaft and
attach. Turn it clockwise 1/8 of
a turn to lock in place.
[ PV-DV401 ][ PV-DV201 ]
201_401.64-67.p65 01/01/18, 17:0967