Filter
Top Products
11
■ SD memory card setup
[SD memory card]
Select "Use" or "Not use" to determine whether or not to
use the SD memory card.
Default: Not use
Important:
• Before removing the SD memory card from the cam-
era, it is necessary to select "Not use" first.
• After inserting the SD memory card, it is necessary
to select "Use" to use the SD memory card.
• When playing or downloading images saved on the
SD memory card, it is necessary to select "ON" for
"Save logs" on the [LOG] tab (☞ page 16) in
advance.
• When the configured image refresh interval is high,
timing or interval of notification or recording may
become inexact and notification or recording may
not carried out as configured when images are
transmitted by multiple users. (☞ page 41) If this
happened, set the image refresh interval lower.
• There are limited times to overwrite on an SD mem-
ory card. When frequently overwritten, it may be at
the end of product life. It is recommended to replace
the SD memory card.
[Notification of remaining]
When the "E-mail notification" function or the
"Panasonic alarm protocol" function is used to provide
notification of the remaining space of the SD memory
card, select a level to be notified at from the following.
50 %/20 %/10 %/5 %/2 %
Default: 50 %
Note:
Notification will be provided each time the remaining
space of the SD memory card reached the values
above.
For example, notification will be provided each time
the remaining space reaches 50%, 20%, 10%, 5%
and 2% when "50%" is selected. Notification may not
always be made at the very moment when the
remaining space of the SD memory card has
reached each value.
[Save trigger]
Select a trigger to save images on the SD memory card
from the following.
FTP error: Saves images when images have failed to
transmit to the FTP server by the FTP periodic trans-
mission function.
Alarm input: Saves images at an alarm occurrence.
Manual: Saves images manually. (☞ Operating instruc-
tions)
Default: FTP error
Notes:
• Select "FTP error" when images are to be transmit-
ted to the FTP server at an alarm occurrence.
• When using the DHCP function (☞ page 53),
images will not be saved on the SD memory card
until an IP address is assigned regardless of the
"Save trigger" setting.
[Overwrite]
Determine whether or not to overwrite when the SD
memory card becomes full.
This setting is available only when "Manual" is selected
for "Save trigger".
ON: Overwrites when the SD memory card becomes
full. (The oldest image is the first to be overwritten.)
OFF: Stops saving images on the SD memory card
when the SD memory card becomes full.
Default: OFF
Configure the settings relating to the SD memory card [SD memory card]
Click the [SD memory card] tab on the "Basic setup" page. (☞ pages 4 and 5: How to display/operate the setup
menu)
The settings relating to the SD memory card can be configured on this page. A mini SD card is used for NW964.