Filter
Top Products
34
Configure the settings relating to the privacy zone ("Privacy Zone" setup menu)
Click the [SETUP>>] button of "Privacy Zone" on the [Image/Position] tab of the "Camera setup" page. (☞ page 25)
When there is a zone that is not to be displayed, set the zone as a privacy zone to not to display. Up to 8 privacy
zones can be set.
Notes:
• Depending on the panning/tilting direction (especially when the tilting degree is 45 ° - 90 °) and the zooming fac-
tor, the area set as the privacy zone may become visible. Make sure that each of the set privacy zone is not visi-
ble after setting it.
• The privacy zone function does not work when the camera is in the process of warming-up just after turning on
the power, or in the process of refreshing the position.
■ Privacy zone
[Mode]
Select a display mode of the privacy zone from the fol-
lowing.
Gray: The privacy zones will be displayed in gray.
Mosaic: The privacy zones will be displayed with a
mosaic effect.
OFF: Does not display the privacy zones.
Default: OFF
■ Zone setting
[Zone select]
Click [i] of "Zone No" and select a zone number (1-8)
from the pull-down menu.
An asterisk (*) next to the zone number indicates that
the privacy zone has already been set for the number.
A blinking mask will be displayed at the center of the
image displayed on the [Image/Position] tab.
Operate the camera with the panning/tilting/zooming
operations to cover the area to be covered by the blink-
ing mask.
This setting is performed after operating the camera
with the panning/tilting/zooming operations to determine
the size and position for mask matching with hidden
areas.
To delete the registered zone, click the [DEL] button
after designating the desired zone number to be delet-
ed.
Click the [CANCEL] button to cancel the application or
to delete the setting.
Notes:
• Set the privacy zone larger than the size of an object
to be hidden. To raise the precision of the privacy
zone placement especially when the zoom is on the
WIDE side, it is recommended to set the privacy
zone with the zoom range between 1x and 3x.
• Panning, tilting and zooming operations can also be
carried out on the [Image/Position] tab.
the TELE side allows users to obtain correct focus at
storing zoom operation. The programmed quantity is
selectable from the following. The patrol operation angle
ranges from 0 degree to –90 degrees. The digital flip
function is disabled.
ZOOM buttons
FOCUS buttons
BRIGHTNESS buttons
Control pad/buttons
[PRESET]
Refer to Operation Instructions for how to operate the
buttons.
[CLOSE] button
Click this button to close the "PATROL" setup menu.