Filter
Top Products
54
[Default gateway]
When not using the DHCP function, enter the default
gateway of the camera.
Default: 192.168.0.1
<Unavailable IP addresses for the default gate-
way>
0.*.*.*
*.*.*.0
255.*.*.*
*.*.*.255
127.0.0.1
Class D addresses (224.0.0.0 - 239.255.255.255)
Class E addresses (240.0.0.0 - 255.255.255.255)
Note:
These IP addresses for the default gateway are
unavailable even when using the DHCP function.
Refer to the network administrator for further infor-
mation about the settings of the DHCP server.
[HTTP port]
Assign the port numbers independently.
The following port numbers are unavailable since they
are already in use.
Available port number: 1 - 65535
Default: 80
<Port numbers already in use>
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162,
995, 10669, 10670
[DNS]
Select "AUTO" or "MANUAL" to determine whether or
not to use the DNS. When "MANUAL" is selected, it is
necessary to configure the settings for the DNS.
When using the DHCP function, it is possible to obtain
the DNS address automatically by selecting "AUTO".
Refer to the network administrator for further information
about the settings.
Default: MANUAL
[Primary DNS], [Secondary DNS]
When "MANUAL" is selected for "DNS", enter the IP
address of the DNS. Refer to the network administrator
about the IP address of the DNS.
[Line speed]
Select the line speed for data transmission from the fol-
lowing. It is recommended to use the default setting
"AUTO".
AUTO: Line speed will be applied automatically.
100M-FULL: 100 Mbps full-duplex
100M-HALF: 100 Mbps half-duplex
10M-FULL: 10 Mbps full-duplex
10M-HALF: 10 Mbps half-duplex
Default: AUTO
[FTP access]
Select "Allow" or "Forbid" to determine whether to allow
or forbid the FTP access.
Default: Forbid
[Total bit rate]
Select the total bit rate for data transmission from the
following.
Unlimited/64 kbps/128 kbps/256 kbps/512 kbps/
1024 kbps/2048 kbps/4096 kbps
Default: Unlimited
Notes:
• When selecting "64 kbps", select "OFF" for "Audio
mode" on the "Audio" tab. (☞ page 35)
• When "64 kbps" is selected, it is impossible to carry
out the live transmission of JPEG images and the
FTP periodic transmission simultaneously.
• When "Total bit rate" (☞ page 54) is set low, taking a
picture using the one shot button may not function
depending on the use environment.
In this case, select "QVGA" for "Image capture size"
of "JPEG setup" on the [JPEG/MPEG-4] tab
(☞ page 20) or set "Image quality" of "JPEG setup"
lower.