Filter
Top Products
64
Initialize/restart the camera [Initialization]
Click the [Initialization] tab of the "Maintenance" page. (☞ pages 4 and 5: How to display/operate the setup menu)
Initialization of the settings and data of the camera and restarting of the camera can be performed on this page.
[Initialize camera setup data (Except network and
preset setup data)]
Click the [Execute] button to reset the settings to the
default. Note that the network settings and the preset
position setting will not be reset.
It is impossible to operate the camera for around 2
minute after the initialization.
[Initialize HTML data]
Click the [Execute] button to reset the HTML files to the
default. It is impossible to operate the camera for
around 2 minute after the initialization.
[Initialize setup data and HTML data]
Click the [Execute] button to reset the settings of the
camera and the HTML files to the default. Note that the
network settings and the preset position setting will not
be reset. It is impossible to operate the camera for
around 2 minute after the initialization.
[Restart]
Click the [Execute] button to restart the camera. It is
impossible to operate the camera for around 2 minute
after restarting the camera.
Notes:
• To initialize the network settings (☞ page 53), do the
following.
1. Turn off the power of the camera.
2. Turn on the power of the camera while holding
down the [INITIAL SET] button of the camera,
and wait around 5 seconds without releasing the
[INITIAL SET] button.
3. Wait around 1 minute after releasing the button.
The camera will start up and the settings includ-
ing the network settings will be initialized.
• When the notifiction function is on, notification will be
provided to the registered addresses (mail address
or IP address) when the SD memory card has failed
to mount after the restart or when the inserted SD
memory card is locked. (☞ pages 47 and 48)
[Position refresh]
The camera position can be refreshed. When the cam-
era has moved from the correct home/preset position
during normal use, use this function to correct the cam-
era position.
It is impossible to operate the camera during the posi-
tion refresh process (for around 2 minute).
Notes:
• Please wait for approx. 2 minutes before starting
operation if initialization, restart, or position refresh
was performed.
• The DIP switch on this unit is used for initialization of
the network setting (☞ page 53). (Refer to the
Installation Guide.)
• The notification function allows users to provide the
notification of the error to the specified mail address
and an original alarm destination when an error such
as no SD card loaded after restart or a locked SD
card loaded occurs. (☞ pages 47 and 48)