Filter
Top Products
44
Configure to detect motion in areas without the preset positions
Configure whether or not to detect motion when the camera is not at the preset position by setting the detection sen-
sitivity. The sensitivity can be set by configuring "VMD area setting except Preset position". When determining
whether to detect motion even when the camera is not at the preset position, all areas except areas used for the
time and date display of "OSD position" will be subject to the detection. The VMD area setting is unavailable.
[Status]
Select "ON" or "OFF" to determine whether or not to
carry out the VMD function.
ON: Carries out the VMD function
OFF: Does not carry out the VMD function
Default: OFF
[Detection sensitivity]
Select a sensitivity level in the detection area from the
following.
1 (Super high)/2/3/4 (High)/5 (Middle)/6 (Low)
Default: Middle
Important:
Click the [SET] button after completing the settings.
The setting will not be applied unless the [SET] but-
ton is clicked.