Filter
Top Products
54 55
IP300 Manual
3.19 Send Mail on Alarm
When you click on the “Send Mail On Alarm” box, an email with picture will
automatically be sent if alarm is triggered. (Make sure your Mail Service
Settings are correct, gure 9.1)
NOTE: Each time an alarm is triggered, 6 snapshots will be sent via email. Each
alarm will last for 60 seconds.
Upload Image on Alarm
Figure 10.4
Set Upload Image on Alarm to have all images sent to FTP le once alarm is
armed.
Upload Intervals. You can set the intervals at which images are uploaded (in
seconds). Please note the Total Alarm Time for each incident is 60 seconds.
Scheduler
When you arm your camera to alarm is up to you. Yu can set the schedule by
days, Monday through Friday, divide each day into 24 hours and even subdivide
hours into quarter. When you click on the times you want the camera armed, the
section will turn blue to indicate your times. Click again to undo schedule and
the eld will return to original gray color.
NOTE: If you do not use the scheduler, the camera will alarm anytime motion is
detected.
Figure 10.5
Trigger Level
Option:
High for closed circuit external alarm devices.
Low for open circuit external alarm devices. When an object moves close to
camera, alarm will trigger.
When alarm is switching off, alarm will trigger as well.
Figure 10.1
There are also two options for output level.
High : if the I/O pins work as switch for closed circuit devices.
Low: if the I/O pins work as a switch for open circuit alarm devices.
3.18.4 IO Pins for IO Alarm Linkage
IO PINS: 1) Output 2) Output 3) Alarm Input 4) Input (GND)
Input Pins. Can be used for 1-way external output sensors (i.e. Person Infrared
Sensor for motion detection). When an external sensor is triggered, IP Camera
will either send an email with a recorded picture or will control the internal relay
output. You must use Pin3 or Pin4 for this and select Alarm.
Input Armed. When using the Inputs Pins in Figure 10.3, you are arming the
device.
Output Pins. These will arm the device when you enable IO linkage on alarm for
alarm over internet. You can also use (INFINITY ICON) and (SPLIT ECLIPTICAL
ICON) to control IO output switch ON/OFF (see gure 4.4)
NOTE: All Pins work as switches only.
Polaroid • Settings Polaroid • Settings