Filter
Top Products
12 13
IP300 Manual
2.1.1.1 Basic Properties
Under Basic Properties you will nd three options. 1) Device ID 2)System
Firmware Version 3) Web UI version (see gure 2.1)
Figure 2.1
Device ID. This is the same ID as the one found on the sticker on the bottom
of your camera. It is called the MAC ID. If there are many IP Cameras on your
device list, you can cross check which camera is which by matching the sticker
numbers of each camera with the ID numbers on the list. If, however, no ID
number is shown on the IP Camera tool, it might be that it is being blocked
by your rewall. Shut Firewall to allow access to your computer or as ID as a
trusted site.
Note: There are two reference numbers. One is the Device MAC ID, the other is
the WI-FI MAC ID, this too is on the sticker at the bottom of the camera. If this
sticker is ever lost, you can recapture it by logging on to your host router and
check the status, the numbers will be found there listed as the IP Camera WI-FI
MAC ID.
2.1.1.2 NETWORK CONFIGURATION
Figure 2.2
In this Window you can congure your network parameter. If you click in the
window requesting an IP from the DHCP server, your camera will be a dynamic
IP (to do this, your router must have a DHCP function and it must be on)
IP Address. Fill in the IP address assigned and make sure it has the same
subnet as your gateway, your computer and your router. (the rst three sets of
numbers should be the same)
Subnet Mask. The default subnet mask for your equipment is 255.255.255.0
Gateway. Make sure the subnet number correspond to your PC’s IO address.
DNS Server. Should be set with the same subnet numbers as the gateway.
Note: You can get subnet mask, gateway and DNS from your Router. Often the
DNS is optional.
HTTP port. Default port number is 80 but you should plug in the port number
assigned for your equipment (ie, 81.801.8001 etc.)
Password: No password.
NOTE; If prompt tells you “subnet doesn’t match, double click to change,” reset
the IP address, subnet mask, gateway and DNS server numbers once again or
enable “Obtain IP from the DHCP server.
2.1.1.3 UGRADE FIRMWARE
Polaroid • Software Polaroid • Software