Getting Started Guide for the VSX Series
© Polycom, Inc. 13
Showing, Moving, and Turning Off the PIP
Your system may be configured to display a Picture-in-Picture (PIP) window.
During a call on a single-monitor system, the PIP displays what your main
camera is sending to the far site. If the far site shows any type of content, the
content appears in the main part of the screen, and the PIP changes to show the
people at the far site.
During a call on a dual-monitor system, what you see on each monitor and in
the PIP depends on how the Polycom system has been configured.
To show, move, or turn off the PIP during a call:
• Press PIP on the remote control to display the PIP on screen.
• While the PIP has a yellow border, press PIP repeatedly to move it to
different corners of the screen.
• After a brief pause, the PIP border turns blue. Then, press PIP to turn
the PIP off.
To swap the views shown in the PIP and the main screen:
1. If the PIP is not showing, press PIP on the remote control to display
the PIP on screen.
2. Press Near twice and select the Swap PIP icon.
Specifying When to Display the PIP
Your system may be configured with specific default behavior for the PIP in
calls. Depending on your system configuration, you may be able to show,
move, or hide the PIP as needed after a call connects.
To specify when to display the PIP:
1. Select System from the Place a Call screen.
2. Select User Settings from the System screen.
3. Select Next to see more settings.
4. Scroll to PIP, press , and select one of these settings: