Polycom 9.0.6 Digital Camera User Manual


 
Getting Started Guide for the VSX Series
26 © Polycom, Inc.
Press Keyboard to use the onscreen keyboard to enter
characters.
4. Press Home to save your change and return to the home screen.
About Multipoint Viewing Modes
What you see during a multipoint call can vary depending on how the
Polycom system is configured, the number of sites participating, and whether
content is shared. The multipoint viewing mode configured on the host system
is the one used in the call. The following table describes the different
multipoint viewing modes.
Setting Description
Auto Allow the system to switch between Discussion and
Presentation modes, based on the interaction between
the sites.
If more than one site is talking at the same time, the
system uses Discussion mode so that all speakers
can be seen.
If one speaker talks without interruption for about
15 seconds, the system uses Presentation mode
so that all participants can see the speaker in a
larger picture.
Discussion View all of the sites at the same time, including your
own site. This is also known as continuous presence.
Systems with:
Single monitor
Dual monitors
See this:
All sites, each in its own window
Speaker on second monitor with
other sites on first monitor, or one
far site on each monitor
Presentation View the person who is speaking. This is also known
as voice activated switching.
The current speaker always sees up to four far sites,
each in its own window, on the first monitor.
Systems with:
Single monitor
Dual monitors
See this:
Speaker in full screen
Speaker on the first monitor and
near site on the second monitor
Full Screen Enable every site in the call to see the speaker full
screen. The current speaker sees the previous
speaker.