Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 15 of 71
Mar 02, 2015
Figure 1.13 [Host Connection] Dialog Box
“USB” can be selected as the communication channel if the USB interface is supported in the PC used.
When selecting “Serial”, select the COM port and baud rate from the drop-down list boxes. COM ports that are
recognized by the host PC are displayed in the Port list. Up to 256 ports can be recognized.
When the OK button is clicked, software tries to establish a connection between the FP5 and the host PC using the
selected communication channels.
Clicking the Cancel button closes the window without making any changes.
(2) [Logging] command
The [Logging] command saves information displayed in the action log window in the log file. When this command is
executed, the log file save dialog box appears. Move to an arbitrary folder, select the log file in the [File name] drop-
down list, and click the Save button; the log file will then be saved. The [Logging] command on the menu bar will be
checked. The check mark will be cleared by clicking the [Logging] command again and saving of the log file will be
stopped. Enabling/disabling the [Logging] command is added to the time stamp. For a log file example, refer to
Common APPENDIX B SUPPLEMENTARY INFORMATION Figure B.3 Log File Example.
Note The log file that was saved the last time is displayed in the log file save dialog box.
Figure 1.14 Log File Save Dialog Box
Clicking the Save button saves the specified log file.
Clicking the Cancel button closes the dialog box without saving the log file.