Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 25 of 71
Mar 02, 2015
Figure 1.33 FP5 Dialog Box
Clicking Yes will open the dialog box to input the password again (Figure 1.32).
Clicking No will initialize the FP5 to its default settings. When initialized, the following stored information will be
deleted or reset to their defaults:
• Password
• FP5 Manager setting
• PR5 file
• ESF file
• Program file
Clicking Cancel will close the dialog box.
Figure 1.34 FP5 Manager Dialog Box
After making any changes to the settings and clicking OK, the dialog box will close and the settings will be enabled.
Clicking Cancel will close the dialog box and discard the changes. The FP5 Manager settings are described below.
• Displaying Mode Contents
The mode contents that indicate the FP5 state is displayed in the [Programmer] area of the programming parameter
window.
• Standard mode unsecured
The FP5 Manager has not been set.
• Standard mode secured
The FP5 Manager has been set. However, the bank mode or the simple mode have not been set.
• Bank mode secured
The FP5 Manager and bank mode have been set.
• Simple mode secured
The FP5 Manager and simple mode have been set.