Filter
Top Products
PG-FP5 V2.13 EXAMPLE OF OPERATION USING PROGRAMMING GUI
R20UT2924EJ0200 Rev.2.00 Page 68 of 71
Mar 02, 2015
Figure 2.18 [Autoprocedure(E.P.)] Command Execution Result
(8) System shutdown
<1> Remove the target system from the target cable.
Note Turn off power and remove the target system before supplying VDD from the target system.
<2> If no more target devices are to be written to, execute the [Quit] command in the [File] menu to terminate the
programming GUI. All the settings made so far are saved, so they can be restored when the programming GUI is
restarted. (The PR5 files, ESF files and program files are saved to the FP5 internal flash memory.)
<3> Press and hold the POWER button on the FP5 for about 1 second to turn off the POWER LED.
<4> Remove the AC adaptor and USB cable from the FP5.
Note If an error occurred during the above steps, refer to Common 10 TROUBLESHOOTING and APPENDIX A
MESSAGES. In addition, refer to 1.3.2 (6) [Self-Test] command and perform selftesting.
If this does not resolve the problem, see the FAQ (except for Europe area: http://www.renesas.com/support, for
Europe area: http://www.renesas.eu/update) or access http://www.renesas.com/contact/ for inquiry.