Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 45 of 71
Mar 02, 2015
<4> [Mode Control] area
In this area, set the mode setting pins used to control the operation mode of the microcontroller.
Figure 1.63 [Mode Control] Area
[Edit Mode pin] check box
Decide whether or not you need to change the settings of the [Mode pins at connection] check boxes. Selecting the [Edit
Mode pin] check box allows changing of the settings.
[Pulse number] box
Displays the count of the pulses output from the FPMD0 pin. The pulse count is modified depending on the interface
mode.
[Mode pins at connection] area
This dialog box is used to select the pin to control the mode pin of the target microcontroller from FPMD0 to FPMD5
pins of target connector.
Note For the FPMD0 to FPMD5 pins of target connector, refer to Common 7.4. Target Connector.
[Output] check box
This dialog box is used to select the pin to control the mode pin of the target microcontroller from FPMD0 to FPMD5
pins of target connector. A selected check box is output, and a cleared check box is input.
[High/Low] check box
Set the level of the selected FPMD0 to FPMD5 pins to High or Low.
[Enable target Reset] check box
When this box is checked, the RESET
¯¯¯¯¯¯
terminal will change to the input mode (Hi-Z). Immediately after execution of
the various commands, FP5 will detect the leading edge of the signal entering the RESET
¯¯¯¯¯¯
terminal. Until a signal is
detected, “Waiting for RESET...” will be displayed in the action log window, and the transition to the flash memory
programming mode will be put on hold. When the signal is detected, the transition will be resumed. And right before
each commands are completed, FP5 will detect the leading edge of the signal entering the RESET
¯¯¯¯¯¯
terminal. Until a
signal is detected, “Waiting for RESET” will be displayed in the action log window, and the termination of the flash
memory programming mode will be put on hold. When the signal is detected, the flash programming mode is ended.