Filter
Top Products
PG-FP5 V2.13 EXAMPLE OF OPERATION USING PROGRAMMING GUI
R20UT2924EJ0200 Rev.2.00 Page 58 of 71
Mar 02, 2015
(5) Startup of programming GUI
<1> Click the Start menu, “All Programs”, point to “Renesas Electronics Utilities”, “Programming Tools”, and then
select “PG-FP5 Vx.xx” of “PG-FP5 Vx.xx” to start the Programming GUI. The valid communication modes are
automatically detected in the order of the USB, and then the serial interface.
Figure 2.1 Connection Between Programming GUI and FP5
<2> The communication mode can also be selected by cancelling this operation with the Cancel button and selecting
the [Setup host connection] command in the [Programmer] menu.
Figure 2.2 [Setup host connection] Command
<3> Perform settings according to the communication port connected to the FP5.
Figure 2.3 Communication Parameter Setup
<4> Click the OK button to enable the new port settings.