Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 50 of 71
Mar 02, 2015
(c) [Advanced] tab in Device Setup dialog box
On the [Advanced] tab, the operation area can be configured.
Figure 1.72 Device Setup Dialog Box - [Advanced] Tab
This tab consists of the following items.
<1> [Operation Area] area
In this area, specify the range in units of blocks in which commands such as flash memory programming are applied.
Also specify the lock bit and OTP settings in units of blocks, and some other command options related to the operation
area.
In this area, [User Area], [Data Area], and [UB Area] tabs can be switched for settings. All the specified blocks are
enabled for the [Blank check], [Erase], [Program], [Verify], [Read], and [Autoprocedure (E.P.)] commands.
The operation area of the [Checksum] command depends on the checksum calculation mode.
Addition: In each of the [User Area], [Data Area], or [UB Area], if at least one block is selected, all the blocks of the
selected area is handled as the operation area.
CRC: In each of the [User Area], [Data Area], or [UB Area], the area from the minimum block to the maximum block of
the selected blocks is handled as the operation area.
Check the check boxes in the [Block No.] column to specify the operation area.
Check the check boxes in the [Lock bit] column to specify the lock bits.
Check the check boxes in the [OTP] column to specify the OTP.
Checking the relevant buttons in the area indicated by <2> allows control of the check boxes.
<1>
<2>