Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 47 of 71
Mar 02, 2015
<5> [ID code] area
In this area, serial programming ID code authentication is performed before each command is executed in ID
authentication mode. Also, the serial programming ID code or the OCD ID code is set. Enter the serial programming ID
code for authentication in the [ID] box. Enter the serial programming ID code or the OCD ID code to be set in the
[Setting] box. When the [Set ID Code(D)] command is executed, the settings in the [Setting] box will be reflected in the
target device. For details on serial programming ID code and OCD ID code, refer to the user’s manual of the target
device.
Note Authentication proceeds with the ID code entered in the [Setting] box in case of failure in authentication with the
code entered in the [ID] box.
Note For RX devices, input the value in this order: ID1, ID2, …, ID16.
Example: When Effective data bytes = 16, ID code = ID1=01h, ID2=02h, ID3=03h, ID4=04h, ID5=05h, ID6=06h,
ID7=07h, ID8=08h, ID9=09h, ID10=0Ah, ID11=0Bh, ID12=0Ch, ID13=0Dh, ID14=0Eh, ID15=0Fh,
ID16=10h
-> ‘ID Code’ 0102030405060708090A0B0C0D0E0F10
Figure 1.65 [ID code for authentication] area
[Set ID Code after Program] check box
When a check mark is placed in this box, the [Set ID Code] command is automatically executed after the [Program] and
[Autoprocedure(E.P.)] commands are executed.
<6> [Security mode] area
In this area, select the mode to be used from among the available modes (Use ID Authentication Mode, Use Command
Protection Mode, and Disable serial programmer after Program).
For details on modes and security functions, refer to the user’s manual of the target device.
Figure 1.66 [Security mode] area
[Use ID Authentication Mode] option button
Select this button to use ID authentication mode. When the target device is in ID authentication mode, serial
programming ID code authentication is performed before each command is executed. When the target device is in
command protection mode, executing the [Set ID Code] command puts the target device in ID authentication mode and
the settings made in the [Setting] box in the [ID code] area will be reflected in the target device as the serial
programming ID code.
[Use Command Protection Mode] option button
Select this button to use command protection mode. When the target device is in command protection mode, executing
the [Set Security] command allows the security settings made in the [Command Protection] area to be reflected in the
target device. When the target device is in ID authentication mode, executing the [Configuration Clear after Erase] puts
the target device in command protection mode.