Filter
Top Products
Installation and Connections
Installation
50
Installation and Connections
Installation
Removing/Attaching the Cable
Cover
To remove the cable cover
The cable cover is attached to the camera at the factory.
You can remove it, if necessary.
1
Release the two screws on the cable cover.
2
Hold the lower ends of the cable cover and pull it
toward you.
To attach the cable cover
1
Insert the projections on the upper ends of the cover
into the camera, then push in the cover at both ends.
2
Tighten the two screws on both ends of the cover.
Note
Never carry the camera by holding the cable cover.
Attaching an Interface Board
Attach an interface board (not supplied) to the card slot
on the rear of the camera.
1
Loosen the two screws to remove the card slot
cover.
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
DATA MIX
OFF ON
OFF ON
IN VISCA RS-232C OUT
DC IN 12V
R
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
DATA MIX
OFF ON
OFF ON
IN VISCA RS-232C OUT
DC IN 12V
R
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
DATA MIX
OFF ON
OFF ON
IN VISCA RS-232C OUT
DC IN 12V
R