Filter
Top Products
Chapter 1 Overview
Chapter 1 Overview 11
High-performance viewfinder (DXF-801/
801CE)
• High resolution (600 TV lines of horizontal
resolution)
• Large-diameter eye cup for easier viewing and
focusing
• PEAKING potentiometer for vertical and horizontal
detail control
• Two indicators can be used as TALLY indicators.
• Tough die-cast aluminum body
• DISPLAY switch that can turn the character display
on and off
• Light that can light the lens control elements
• Switching the aspect ratio automatically between
16:9 (wide screen) and 4:3 (standard screen) when
used with the DXC-D50WS/D50WSP
VTR data display
When connected to a VTR, the DXC-D50/D50P/
D50WS/D50WSP is able to display the following data
on the viewfinder screen.
• Time values (counter, time code, or user bit values)
• VTR audio levels
• Remaining tape time
• VTR operation mode
• Remaining battery capacity (when using an Anton
Bauer Intelligent Battery System)
Features on the DXC-D50WS/
D50WSP
Features only on the DXC-D50WS/D50WSP is
described in this section. See “Features on the DXC-
D50/D50P/D50WS/D50WSP” (page 9) for common
features on a 4:3 standard-screen type digital video
camera and 16:9 wide-screen type digital video
camera.
Switchable between 16:9 and 4:3 aspect
ratios
A simple menu operation provides instant switching
between the 16:9 and 4:3 aspect ratios. In 4:3 mode, a
screen equivalent to a 4:3 screen is obtained through
digital processing of the 16:9 video signals produced
by the wide aspect CCD. (See page 67.)
Wide-aspect ID signals
A menu setting is available to add wide-aspect ID
signals
1)
to 16:9-mode video signals.
2)
(See page 67.)
Selection of the safety zone size in 16:9
mode
When the aspect ratio is 16:9, you can change the
safety zone size through menu setting (see page 61.)
..........................................................................................................................................................................................................
1) ID signals complying with EIAJ CPR-1204 (DXC-
D50WS) or complying with ETS WSS (DXC-D50WSP).
2) Video signals refer to the following:
• Video signals output from the VIDEO OUT connector
and MONITOR OUT connector.
• The Y component of Y/C separate signals and the Y
component of component signals output from the VTR
connector.