Filter
Top Products
46 Chapter 3 Shooting
Chapter 3 Shooting
Shooting with the DSR-1/1P
The DXC-D50/D50P/D50WS/D50WSP docks with
the DSR-1/1P to configure a DVCAM digital
camcorder.
The following describes how to shoot using a
DVCAM digital camcorder.
Using the Edit Search Function
While Back Space Editing
While the DSR-1/1P is in recording pause mode, press
and hold the EDIT SEARCH buttons to activate the
search playback function for as long as you hold down
the button. You can use the edit search function to
find the desired tape location after a recording stop
during back space editing or when continuing to record
from any other location on the tape.
1 Dock the DSR-1/1P to the camera head and turn on
the power, then insert a cassette into the DSR-1/1P.
2 Perform steps 2 to 12 in “Basic Procedure for
Shooting” (page 43).
3 Press and hold either of the EDIT SEARCH
buttons (REV or FWD).
The tape is moved in reverse or forward search
mode for as long as you hold down the REV or
FWD button, and the image is shown in the
viewfinder.
To change the playback speed
Press the REV or FWD button down firmly into
the inner position to make the tape move at the
faster speed. Press the button down lightly to
make the tape move at the slower speed.
Note
Do not shut off the camera head’s power while
using the edit search function. The DSR-1/1P may
not be able to find the continue point.
4 Release the REV or FWD button when you find
the tape location where you wish to continue
shooting.
The DSR-1/1P enters recording pause mode.
5 Press the VTR button on the camera head or the
lens.
The DSR-1/1P starts recording.
REV button
FWD button