Filter
Top Products
112
Using a “Memory Stick” – Introduction
2
FN
3
4
5
1
MEMORY/
NET-
WORK
CAMERA
(CHG)
POWER
OFF
ON
MODE
VCR
EXIT
RET.
EXEC
1152x864
REMAIN
23
MEMORY SET
STILL SET
BURST
QUALITY
IMAGESIZE
EXIT
RET.
EXEC
OFF
MEMORY SET
STILL SET
BURST
QUALITY
IMAGE SIZE
EXIT
RET.
EXEC
1152x864
640x480
REMAIN
23
MEMORY SET
STILL SET
BURST
QUALITY
IMAGESIZE
1152
Selecting the size of still image
You can select either of two image sizes.
Still images: 1152 × 864 or 640 × 480. (When the POWER switch is set to CAMERA or
VCR, the image size is automatically set to 640 × 480.)
The default setting is 1152 × 864.
(1) Set the POWER switch to MEMORY/NETWORK(DCR-IP55 only).
(2) Press FN to display PAGE1.
(3) Press MENU, then select STILL SET (still image) in in the menu setting, then
press EXEC (p. 178).
(4) Press r/R to select IMAGESIZE, then press EXEC.
(5) Press r/R to select the desired image size, then press EXEC.
The indicator changes as follows:
1152 640
Note
When still images recorded on your camcorder in 1152 × 864 size are played back on
other equipment that does not support 1152 × 864 size, the full image may not appear.