Filter
Top Products
157
Viewing Images Using your Computer
Viewing images recorded on a “Memory Stick”
(1) Insert a “Memory Stick” into your camcorder.
(2) Connect the AC power adaptor and set the POWER switch to MEMORY/
NETWORK (DCR-IP55 only).
(3) Connect the (USB) jack on your camcorder to the USB connector on your
computer using the supplied USB cable.
USB MODE appears on the LCD screen of your camcorder. Your computer
recognises the camcorder, and the Add Hardware Wizard starts.
(4) Follow the on-screen messages so that the Add Hardware Wizard recognises that
the USB drivers have been installed. The Add Hardware Wizard starts two times
because two different USB drivers are installed. Be sure to allow the installation to
complete without interrupting it.
You cannot install the USB driver if a “Memory Stick” is not in your camcorder.
Be sure to insert a “Memory Stick” into your camcorder before installing the USB
driver.
Connecting your camcorder to your computer using the USB cable
– For Windows users
USB connector
USB cable (supplied)
(USB) jack