Filter
Top Products
Setup Menu List
108
Menu Configuration and Detailed Settings
Tally
Setting the tally
lamps
Front
High / Low / Off
Set the brightness of the tally lamp on the front.
High: To brighten the lamp
Low: To dim the lamp
Off: To not light the lamp
Rear
On / Off
Turn the tally lamp on the rear on/off.
Hours Meter
Displaying the
hours meter
Hours (Sys) The non-resettable accumulated time of use is displayed.
Hours (Reset) The resettable accumulated time of use is displayed.
Reset
Execute/Cancel
Select “Execute” to reset the Hours (Reset) value to 0.
IR Remote
Activating/
deactivating the
Remote
Commander
On / Off Set to “On” to activate remote control operations from the
supplied IR Remote Commander.
Note
The setting automatically returns to “Off” when the
camcorder is turned off.
Battery Alarm
Setting the low
power alarm
Low BATT
5% / 10% / 15% / ... / 45% /
50%
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
BATT Empty
3% to 7% (3%)
Set the battery level at which the BATT Empty warning is
generated.
DC Low Volt1
11.5 V to 17.0 V (11.5 V)
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
DC Low Volt2
11.0 V to 14.0 V (11.0 V)
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
Battery INFO
Showing
information
regarding the
battery pack
(display only)
Type The type (product name) is displayed.
MFG Date The date of manufacture is displayed.
Charge Count The accumulated number of times of charge/discharge is
displayed.
Capacity The estimated total capacity of full charge is displayed.
Voltage The current output voltage is displayed.
Remaining The current remaining level is displayed.
Direct Menu
Setting the Direct
menu function
All / Part / Off All: All Direct menu operations are permitted.
Part: A part of Direct menu operations is permitted.
The
operation is limited depending on the GAIN, SHUTTER,
or WHITE BAL switch setting.
Off: No Direct menu operation is permitted.
i.LINK I/O
Setting for input/
output at the
i.LINK connector
Enable / Disable Enable: To use the i.LINK connector
Disable: To not use the i.LINK connector
Notes
• When you set this item to “Enable,” no signal is fed out
from the SDI OUT connector.
• When the video format is not SP mode, signal input/output
via the i.LINK connector is not enabled, even if this item is
set to “Enable.”
OTHERS
Menu items Subitems and setting values Contents