Filter
Top Products
Administrating the Camera
Sending an Image via E-mail — e-Mail (SMTP) Menu
67
Sending an Image via E-
mail
— e-Mail (SMTP) Menu
When you click in the Administrator
menu, the e-Mail (SMTP) menu appears.
Using the e-Mail (SMTP) function, you can send an
e-mail with an attached image file that has been shot
linked with an external sensor input or with the built-in
motion detection function. The image file can also be
sent periodically.
The e-Mail (SMTP) menu consists of three tabs:
Common, Alarm sending and Periodical sending.
Common Tab — Setting the e-Mail
(SMTP) Function
e-Mail (SMTP)
Select On when you use the e-Mail (SMTP) function.
Notes
• You cannot send an audio file by using the e-mail
sending function.
• The frame rate and operability on the main viewer
may be reduced while a file is being transmitted by the
e-Mail (SMTP) function.
SMTP server name
Type the SMTP server name using up to 64 characters,
or the IP address of the SMTP server.
SMTP port number
Select the textbox and enter a port number from 25 to
65535.
Use TLS
To use the encryption function by TLS, select On.
STARTTLS
To use the encryption function by STARTTLS, select
On.
Authentication
Select whether authentication is required when you send
an e-mail.
Off: No authentication is required when an e-mail is
sent.
On: Authentication is required when an e-mail is sent.
Select one of the authentication methods from the
following and specify the POP server name, User
name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, be sure to select
either or both SMTP or/and POP before SMTP.
POP mode
Select POP3 or APOP (encrypted authentication).
Waiting time after POP authentication
Set the timeout duration. Timeout duration can be set
from 1 to 10000 msec.
POP server name
This is necessary when POP before SMTP is selected
for Authentication.
Type the POP (receiving mail) server name using up to
64 characters, or type the IP address of the POP server.
This setting is necessary when the SMTP server that
sends e-mails performs authentication using the POP
user account.
POP port number
Enter a port number from 110 to 65535.
Authentication mode
Set the user authentication mode.
If you do not use CRAM-MD5, select Login.
User name, Password
Type the user name and password of the user who owns
the mail account using up to 64 characters. This setting
is necessary when the SMTP server that sends e-mails
performs authentication.
e-Mail (SMTP)