Filter
Top Products
Administrating the Camera
Setting the Motion Detection/VMF Function — Motion detection Menu
86
Pass
Edit the pass inspection line according to the following
procedure:
Pass inspection line
By default, one pass inspection line is displayed. The
initial number of vertexes is 2 for each pass inspection
line.
Placing the cursor on the line will turn the cursor into a
cross, and when you drag the line, the whole line will
move.
Placing the cursor on the vertex will turn the cursor into
n, and when you drag the line, the vertex will move.
The arrow displayed in the center of the pass inspection
line shows the direction of inspection. Inspection is
performed when an object passes the pass inspection
position in this direction.
Inspection direction setting
Each time you click , the inspection direction toggles
among the directions left, right and both.
Pass inspection position
Select the pass inspection position from Center, Left
side, Top side, Right side and Bottom side.
Presence
Similar to a active window an inspection area can also be
moved and vertexes can be moved/added or deleted.
If an object is present within the window longer than the
specified time, the presence is acknowledged.
Presence time
Specify the time of presence.
Appear
This criterion is whether an object appeared in the
inspection area.
Similar to an active window, an inspection area can also
be moved and vertexes can be moved/added or deleted.
Disappear
This criterion is whether an object disappeared in the
inspection area.
Similar to an active window, an inspection area can also
be moved and vertexes can be moved/added or deleted.