Filter
Top Products
15
Getting started
, Connect the power cord (mains
lead) to the AC Adaptor and
then to a wall outlet (wall
socket).
During charging, the battery mark in the
display window flashes, and after charging
is completed, “Full” appears.
• The available shooting time on the display
window is calculated as if the camera were used
under the following conditions:
– The mode dial is set to
– [LCD Backlight] or [EVF Backlight] is set to
[Normal]
– Using a “Memory Stick”
– Not using the NightShot or NightFraming
function.
• After charging the battery pack, disconnect the
AC Adaptor from the DC IN jack of your
camera and the wall outlet (wall socket).
To remove the battery pack
Open the battery/“Memory Stick” cover.
Slide the battery eject lever in the direction
of the arrow, and remove the battery pack.
• Be careful not to drop the battery pack when
removing it.
Battery remaining indicators
The battery remaining indicators on the screen or
on the display window show the remaining
shooting or viewing time.
• The battery remaining time on the screen or on
the display window may not be correct under
certain circumstances or conditions.
• When you switch the FINDER/LCD switch or
/CF switch, it takes about one minute for
the correct battery remaining time to appear.
Charging time
Approximate time to charge a completely
discharged battery pack using the AC
Adaptor at a temperature of 25°C (77°F).
4
Power cord
(mains lead)
2 To a wall outlet (wall socket)
1
The available shooting time is indicated
Battery eject lever
Battery pack Charging time
(min.)
NP-FM50 (supplied)
Approx. 150
80
min
LCD screen/Finder
Display window