Filter
Top Products
Embedded DVR User Guide
________________________________________________________________________________________________________
21
SETTING THE REMOTE CONTROLLER ID
When more than one EHV DVR is installed in the same location, you can use one remote controller to control multiple DVRs
– up to 20 DVRs. To control multiple DVRs, you must change the remote controller ID to the DVR ID of the DVR.
To change the remote controller ID:
1. On the DVR, go to SYSTEM > SYSTEM CONFIGURATION.
2. Enter the desired DVR ID number.
3. On the remote controller, press and hold the ID button and enter the desired DVR ID number to operate the
corresponding DVR.
Note The DVR ID must be input as two numbers on the remote controller. You must input 00 for the system ID 0 and
input 01 for 1.