Filter
Top Products
31
(8. 4) Changing OSD (On Screen Display) output
1
Move the “
” to OSD OUTPUT by pushing the [MENU UP], [MENU DOWN] buttons.
2
Select ALL ON or DVI or SDI by pushing the [DATA UP], [DATA DOWN] buttons.
[DATA UP]
[DATA DOWN]
ALL ON DVI SDI
• If set to ALL ON, display will be shown on monitor TVs that are compatible with DVI-D input or 3G/HD-SDI input.
• If set to DVI, display will be shown only on DVI-D output.
• If set to SDI, display will be shown only on 3G/HD-SDI output.
If you do not select the same OSD output as the type of monitor that is connected, the display may disappear. If this
happens, turn the power off and then on, then use the procedure in 7.2 (11) "Returning to factory settings" to reset
the default settings. After that, reset the other settings.
(8. 5) Change of vertical inversion setting
1
Move the “
” to FLIP by pushing the [MENU UP], [MENU DOWN] buttons.
2
Select ON (Vertical inversion image appears.) or OFF by pushing the [DATA UP], [DATA DOWN] buttons.
(8. 6) Change of horizontal inversion setting
1
Move the “
” to MIRROR by pushing the [MENU UP], [MENU DOWN] buttons.
2
Select ON (Horizontal inversion image appears.) or OFF by pushing the [DATA UP], [DATA DOWN] buttons.
(8. 7) Switching of inversion mode display
1
Move the “
” to STATUS DISP by pushing the [MENU UP], [MENU DOWN] buttons.
2
Select ON or OFF by pushing the [DATA UP]-[DATA DOWN] buttons.
When ON is set, the setting status of vertical/horizontal inversion is displayed in the lower right part of the screen.
ࠉF···Vertical inversion is effective.
M···Horizontal inversion is effective.
F M
(8. 8) Change of binning setting
This is a function for increasing the sensitivity by combining (grouping) a matrix of horizontal and vertical pixels into
a single group.
1
Move the “
” to BINNING by pushing the [MENU UP], [MENU DOWN] buttons.
2
Select ON or OFF by pushing the [DATA UP]-[DATA DOWN] buttons.
Note:
Turning the binning setting ON (effective) lowers the resolution.