Filter
Top Products
Vicon Command Summary
The following table lists the Vicon controller key sequence to control the indicated SpeedDome Ultra
VII functions.
If you want to … Use …
Set Auto Iris ON/OFF
(LED indicates Auto Iris state: ON = AUTO)
A/I Toggles state
Set Auto Focus ON/OFF
(LED indicates Auto Focus state: ON = AUTO)
Press and Hold L-Spd
A/P Toggles state
Goto Presets Run/Pgm switch to RUN
Enter 1-79 Enter
Program Presets Run/Pgm switch to PGM
Enter 1-79 Enter
Run PEEL Pattern and Repeat
AUX5
Rotate dome 180° (“Flip”)
AUX6
Start Pattern 1-3 Definition
Run/Pgm switch to PGM
Enter 80-82 Enter
End Pattern Definition
Run/Pgm switch to PGM
Enter 86 Enter
Review Pattern Run/Pgm switch to PGM
Enter 87 Enter
Accept Pattern Run/Pgm switch to PGM
Enter 88 Enter
Run Pattern 1-3 Run/Pgm switch to RUN
Enter 80-82 Enter
Repeat Pattern 1-3 Run/Pgm switch to RUN
Enter 83-85 Enter
Set Pattern to Peel
Enter 89 Enter
Vphase Dome
Note: The A/I LED blinks indicating that you are in the vphase
mode. Enter key sequence again to turn vphase adjustment off.
The A/I LED stops blinking and indicates Auto Iris State.
Run/Pgm switch to PGM
Enter 93 Enter
• Pan Right to increment
• Pan Left to decrement
Start Dome Configuration Menu
See Operating the Dome Configuration Menu on page F–3.
Enter 94 Enter
Turn IR Mode On Run/Pgm switch to PGM
Enter 95 Enter
Turn IR Mode Off Run/Pgm switch to PGM
Enter 96 Enter
Reset Dome Run/Pgm switch to PGM
Enter 97 Enter
F–2 SpeedDome Ultra VII Operator's Manual