Cannon 300II Photo Scanner User Manual


 
8
BEFORE YOU BEGIN ...
Daily handling
Before using the equipment, make sure you and your co-workers
read the following warnings about using this equipment.
PAY ATTENTION TO THESE WARNINGS! FAILURE
TO FOLLOW THESE WARNINGS COULD RESULT
IN INJURY FROM FIRE OR ELECTRICAL SHOCK!
WARNING
Always observe these warnings when using the scanner. Failure
to follow these warnings could result in injury due to fire or elec-
tric shock.
Do not set up the scanner in a location close to flammable sol-
vents such as alcohol and paint thinners.
Do not cut, damage or modify the power cord, do not pull or bend
the power cord excessively, and do not place heavy objects on the
power cord.
Never plug in or unplug the power cord with wet hands.
Do not place objects on top of the scanner as such objects could
fall and cause injury. Do not plug the scanner into a multi-socket
adapter.
Do not knot or bundle the power cord, and ensure that the plug is
pushed fully into the power outlet.
Use only the power cord supplied with the scanner.
Do not attempt to disassemble or modify the scanner. There are
no user-serviceable parts inside the scanner.
Do not use flammable sprays or aerosols near the scanner.
Switch the scanner off and unplug the power cord before cleaning
the scanner.
To clean the unit, use a cloth lightly dampened with water or a
mild detergent.
If the scanner emits an unusual noise, odor, smoke or sparks, or if
the scanner will not function when switched on, immediately
switch the scanner off, unplug the power cord and contact an au-
thorized Canon dealer or service center.
Before you move the scanner even a short distance, switch the
scanner off and unplug the power cord.
CAUTIONS
Do not set up the scanner on sloping, wobbly or otherwise un-
stable surfaces or in locations affected by excessive vibration. The
scanner could cause injury if it falls over or slides off the surface.
Do not block the ventilation slots as this could result in a fire due
to the build up of heat inside the scanner.
Do not place vessels containing liquids (cups, vases, etc.) or small
metal objects (paper clips, staples, necklaces, etc.) on top of the
scanner. Liquids or metal objects falling into the scanner could
cause an electric shock or fire. If any liquids or metal objects fall
into the scanner, immediately switch the scanner off, unplug the
power cord and contact an authorized Canon dealer or service
center.
Do not set up the scanner in dusty or humid locations as this could
result in an electric shock or fire.
Do not place heavy objects on top of the scanner as such objects
could fall and cause injury.
MS 300_english.p65 07.5.14, 10:148