Filter
Top Products
39
■ Printing (DMP mode) ■
3. Set the number of prints that you want to make (1 to 99).
Press the Print Number Setting key on the operation panel or
the operation keyboard to set the number of prints. If you press
the plus (+) key, the number increases, and if you press the
minus (–) it decreases.
If you want to change the number you have already
set, press the Clear/Stop key (C/ ) to reset the num-
ber to 1, and then set the number of prints you want to
make once again.
4. Make the Print mode settings if required.
5. Press the Start key on the operation panel or the operation
keyboard to start printing.
You can cancel printing at any time by pressing the
Stop/Clear key (C/ ).
MS 300_english.p65 07.5.14, 10:1439