Filter
Top Products
26
1
Connect the charger to a power outlet.
Connect the power plug to a power outlet,
and connect the power cord to the charger.
When no battery is attached, all the
indicator lamps will be off.
2
Remove the protective covers
from the charger and battery.
Remove the protective cover on the
charger by sliding it out.
3
Recharge the battery.
Slide in the battery into the charger’s
slot as shown by the arrow, and make
sure it is securely attached. You can
attach the battery to slot A or B.
X The Charge level indicator will light in
green and charging will start.
X
When the battery is fully charged, all three Charge
level indicators will light (50%/80%/100%).
It takes about 2 hours to fully recharge a
completely exhausted battery.
The time
required to recharge the battery depends on the
ambient temperature and battery’s charge level.
Recharging the Battery
The charger cannot charge any battery other than Battery Pack LP-E4.
Battery Pack LP-E4 is dedicated to Canon only. Using it with a non-Canon battery charger
or product may result in malfunction or accidents for which Canon cannot be held liable.
For battery calibration (p.28), it is best to do it after the battery is nearly exhausted.
If you do the calibration with a fully charged battery, it will take about 12 hours to
complete the calibration (power discharge) and the battery recharging (approx. 10
hours to discharge, and approx. 2 hours to fully recharge).
When two battery packs are attached to the charger, the battery attached first will be charged first,
then the other battery will be charged. Although one battery can be recharged and another
calibrated (p.28) at the same time, two batteries cannot be recharged or calibrated at the same time.
COPY