Filter
Top Products
65
O Custom White Balance
4
Photograph a solid-white object.
The plain, white object should fill the
center spot metering circle.
Set the lens focus mode switch to
<g>, then focus manually. (p.86)
Shoot the white object so that a
standard exposure (gray) is obtained.
If it is underexposed or overexposed,
a correct white balance setting might
not be obtained.
X The Custom WB data will be
registered in the camera. When it is
completed, a message will appear on
the screen.
To use the Custom WB, see
“Selecting and Shooting with the
Custom WB data” (p.67).
A Custom WB data can also be registered as follows:
1. Press the <B> button and turn the <5> dial to select <O>.
(p.63)
2. Then turn the <6> dial to select the No. under which the Custom
WB is to be registered.
3. Press the <A> button.
→ [ * ] will blink on the rear LCD panel.
4. Follow step 4 above to photograph a solid-white object.
→ The Custom WB will be registered under the selected No. and a
completion message will appear on the screen.
When a picture is taken, the registered Custom white balance will be
applied. (This registration method does not require the “Selecting and
Shooting with the Custom WB data” step on page 67.)
If [Correct WB may not be obtained with the selected image] is
displayed in step 4, go back to step 1 and try again.
The captured image will not be recorded to the memory card.
COPY