Filter
Top Products
Recording
26
When using a tripod
: Do not
leave the viewfinder exposed to
direct sunlight as it may melt
(due to concentration of the light
by the lens). Do not use tripods
with fastening screws longer
than 5.5 mm (0.2 inch). Doing
so may damage the camcorder.
Recording Still Images
1 Holding the lock button pressed
down, set the POWER switch to
CAMERA.
2 Move the / switch to
(memory card).
3 Press halfway.
• Once the focus is automatically
adjusted, will turn green and one or
more AF frames appear.
• When you press on the
wireless controller, the still image is
recorded immediately.
4 Press fully.
The CARD access indicator will flash
as the image is being recorded.
IMPORTANT
Avoid the following actions while the card
access display ( ) appears on screen and
when the CARD access indicator is on or
flashing. Failing to do so may result in
permanent data loss.
- Do not open the memory card slot cover and
do not remove the memory card.
- Do not disconnect the power source or turn off
the camcorder.
- Do not change the position of the
/
switch or the operating mode.
NOTES
If the subject is not suitable for autofocus,
turns yellow. Adjust the focus manually ( 44).
When the subject is too bright, “OVEREXP.”
starts flashing. In such case, use the optional
FS-H37U ND filter.
Zooming
POINTS TO CHECK
: In addition to the 10x optical
zoom, the 200x digital zoom is also
available ( 31).
Before using a memory card for the first
time, be sure to initialize it with this
camcorder ( 56).
(10)
PHOTO
PHOTO
PHOTO
( 10)
Zoom out
Zoom in