Filter
Top Products
76
Trouble?
Printing
Editing
Others
List of Messages
Problem Solution
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to mode and restore the connection.
–
Problem Solution
Cannot record with this
camcorder video input from an
external video device
connected to the HDV/TV
terminal using a DV cable.
Set [AV DV] to [OFF]. 33
Wrong signal standard. Dubbing may work using the AV IN/OUT
terminal.
Refer also to the instruction manual of the connected device.
–
Problem Solution
A rattling can be heard from the
camcorder.
The internal lens fixture can move when the camcorder is turned
off. This is not a malfunction.
–
Message Explanation/Solution
SET THE TIME ZONE,
DATE AND TIME
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
24
CHANGE THE BATTERY
PACK
Battery pack is exhausted. Replace or charge the battery pack. 18
THE TAPE IS SET FOR
ERASURE PREVENTION
Cassette is protected. Replace the cassette or change the position
of the protect switch.
80
REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove the
cassette and reinsert it.
19
CHECK THE HDV/DV
INPUT
(Appears only if a DV cable is
connected)
The DV cable is not correctly connected to the HDV/DV terminal, or
the connected digital device is turned off.
57
The video input signal is in a different television system (PAL or
SECAM).
–
CONDENSATION HAS
BEEN DETECTED
Condensation has been detected in the camcorder. 82
CONDENSATION HAS
BEEN DETECTED
REMOVE THE CASSETTE
Condensation has been detected in the camcorder. Remove the
cassette.
82
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –