Filter
Top Products
162
Appendix
The flash does not
fire.
1)If
?
(Flash Off) is selected as the flash mode, change to
another mode (page 35).
2)If battery power is load, replace them with a full set of new
ones.
3)If a BEST SHOT scene that uses
?
(Flash Off) is selected,
change to a different flash mode (page 35) or select a
different BEST SHOT scene (page 64).
Camera powers
down during Self-
timer countdown.
The batteries may be dead.
The monitor screen
image is out of
focus.
1)You may be using Manual Focus and have not focused the
image. Focus the image (page 46).
2)You may be using
´
(Macro) or Á (Super Macro) for
scenery or portraits. Use Auto Focus for scenery and portrait
shots (page 46).
3)You may be trying to use Auto Focus when shooting a close-
up shot. Use the
´
(Macro) or Á (Super Macro) for close
ups (page 46).
There is digital
noise in images.
1)Sensitivity may have been increased automatically for a dark
subject, which increases the chance of digital noise. Use a
light or some other means to illuminate the subject.
2)You may be attempting to shoot in a dark location with
?
(Flash Off) selected, which can increase digital noise and
make images appear coarse. In this case, turn on flash (page
35) or use lights for illumination.
3)Flash assist or dynamic range may be enabled for snapshots,
which can cause an increase in digital noise. Use a light or
some other means to illuminate the subject.
A recorded image
was not saved.
1)Camera power may have been turned off before the save
operation was complete, which will result in the image not
being saved. If the battery indicator shows , replace
batteries (alkaline) or charge batteries (Ni-MH) as soon as
possible.
2)You may have removed the memory card from the camera
before the save operation was complete, which will result in
the image not being saved. Do not remove the memory card
before the save operation is complete.
Though available
lighting is bright,
the faces of people
in the image are
dark.
Not enough light is reaching the subjects. Change the flash
mode setting to
<
(Flash On) for daylight synchro flash (page
35), or adjust EV shift to the + side (page 40).
Problem Possible Cause and Recommended Action