Filter
Top Products
35
Snapshot Tutorial
1. Press ð (Flash up) to open the
flash unit.
• The flash will not fire if the flash unit
is not open.
2. In the REC mode, press [2] ( )
once.
3. Use [4] and [6] to select the flash setting you want and then press
[SET].
4. Press the shutter button to shoot.
• Note that the flash unit does not close automatically. After
you are finished using it, you need to close it by hand.
Using Flash (Flash)
Auto Flash
Flash fires automatically in accordance with exposure
(amount of light and brightness) conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to brighten a
subject that normally comes out dark due to daylight or
backlight (daylight synchro flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can be used to
reduce the chance of redness in the subject’s eyes.
Flash
ð (Flash up)
[2] ( )
>
?
<
¥
N
< indicates the flash will fire.
Back lamp
Flashes red while the flash is charging to indicate that image
recording is disabled.