Filter
Top Products
2-6
Cisco Video Surveillance 2630 IP Dome User Guide
OL-24130-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2630 IP Dome
Step 8 Attach the base plate to the conduit base with the four screws, provided (see Figure 2-4).
Note Make sure the that gasket is clean and in place.
Figure 2-4 Attaching Base Plate to Conduit Base
Step 9 Put the an category 5 or higher Ethernet cable through the appropriate cable entry hole in the conduit
base and the opening in the base plate and connect the cable to the LAN port on the IP dome (see
Figure 1-1 on page 1-3).
Caution Do not lift the IP dome by the Ethernet cable.
Step 10 Put the power cable through the appropriate cable entry hole in the conduit base and the opening in the
base plate and connect it to the power input on the IP dome (see
Figure 1-1 on page 1-3).
1 Ceiling or wall
2 Rubber sheet
3 Conduit base
1 Conduit base
2 Gasket
3 Base plate