Filter
Top Products
2-18
Cisco Video Surveillance 2630 IP Dome User Guide
OL-24130-02
Chapter 2 Getting Started
Adjusting the Video Image
or away from the camera. Take care not to pull the lens completely away from the camera.Obtain
a sharp picture in both wide-angle and telephoto positions. When the focus is set as desired, use
the Allen wrench to tighten the back focus hex screw.
Caution Do not manually adjust the focus or zoom for the IP camera. Attempting to manually do so may damage
the IP camera lens. Instead, use the Focus/Zoom window in the configuration software to remotely set
the focus and zoom for the IP camera.
Figure 2-13 Adjusting the Camera Lens on the 2630 IP Dome
Step 4 Remove the analog monitor cable from the analog video output port.
Step 5 Replace the privacy shield by squeezing it to fit inside the four tabs on the camera unit.
Make sure to adjust the privacy shield inside the dome and trim ring assembly so that it does not block
the lens from capturing video.
Step 6 Align the tab on the dome assembly with the opening in the base plate, press the dome assembly into
place, and securing the three TORX screws
1 Rotation wheel
2 Panning lock screw
3 Tilt lock screws (2)
4 Back focus hex screws (3)
1
2
3
4