Filter
Top Products
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
17
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
Show/hide
calldetails
Controllingandmonitoringacall
You can control and monitor several call features using the
Call Control page.
Adjustingthesoundvolume
Use + and - on the volume control bar to adjust the sound
volume of your system (not the keyboard + and - keys).
Mutingthemicrophone
Use the Mute button when you want to deactivate the
microphone for privacy reasons.
When the microphone is muted, the button is replaced by an
Unmute button. Use this button to re-activate the microphone.
Controllingthecamera
First, press the Camera Control button. Then, in the window
that opens, use + and - to adjust the zoom and the arrow keys
to adjust the camera’s angle.
If a camera preset is defined it is listed to the right. Apply the
preset by clicking its name.
Callsettings
When you load the Call Control page, the default call bit rate
and the default call protocol are shown in the Call bit rate and
Call protocol fields, respectively. If preferred, you can select
another bit rate or another protocol from the drop down lists.
You can not change these settings during a call.
Calldetails
Press Show details while in a call to provide information on
call rate, encryption, as well as important video and audio
parameters.
Hide details removes the information.
Microphonemute
Volumecontrol
Call Control
Cameracontrol
Callprotocol
Callbitrate
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Web interface