Cisco Systems CTSSX20PHD12XK9 Security Camera User Manual


  Open as PDF
of 80
 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
47
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
NetworkServicesSNMPCommunityName
Enter the name of the Network Services SNMP Community. SNMP Community names are used
to authenticate SNMP requests. SNMP requests must have a password (case sensitive) in order
to receive a response from the SNMP Agent in the codec. The default password is "public".
If you have the Cisco TelePresence Management Suite (TMS) you must make sure the same
SNMP Community is configured there too. NOTE: The SNMP Community password is case
sensitive.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: NetworkServices SNMP CommunityName: "public"
NetworkServicesSNMPSystemContact
Enter the name of the Network Services SNMP System Contact.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: NetworkServices SNMP SystemContact: ""
NetworkServicesSNMPSystemLocation
Enter the name of the Network Services SNMP System Location.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: NetworkServices SNMP SystemLocation: ""
NetworkServicesSSHMode
SSH (or Secure Shell) protocol can provide secure encrypted communication between the
codec and your local computer.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: The SSH protocol is enabled.
Off: The SSH protocol is disabled.
Example: NetworkServices SSH Mode: On
NetworkServicesSSHAllowPublicKey
Secure Shell (SSH) public key authentication can be used to access the codec.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: The SSH public key is allowed.
Off: The SSH public key is not allowed.
Example: NetworkServices SSH AllowPublicKey: On
NetworkServicesTelnetMode
Telnet is a network protocol used on the Internet or Local Area Network (LAN) connections.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: The Telnet protocol is enabled.
Off: The Telnet protocol is disabled. This is the factory setting.
Example: NetworkServices Telnet Mode: Off
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings
 previous next