Cisco Systems CTSSX20PHD12XK9 Security Camera User Manual


  Open as PDF
of 80
 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
33
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
CamerasCamera[1..1]GammaLevel
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. NOTE: Requires the Gamma Mode to be set to Manual.
Requiresuserrole: ADMIN
Valuespace: <0..7>
Range: Select a value from 0 to 7.
Example: Cameras Camera 1 Gamma Level: 0
CamerasCamera[1..1]IrSensor
The IR sensor LED is located in the front of the camera and flickers when the IR sensor is
activated from the remote control. Both the Codec C Series and PrecisionHD camera have IR
sensors, and only one of them needs to be enabled at the time.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: Enable the IR sensor on the camera.
Off: Disable the IR sensor on the camera.
Example: Cameras Camera 1 IrSensor: On
CamerasCamera[1..1]Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen.
Requiresuserrole: ADMIN
Valuespace: <Auto/On/Off>
Auto: When the camera is placed upside down the image is automatically mirrored. Use this
setting with cameras that can be mounted upside down, and that can auto detect that the
camera is mounted upside down.
On: See the selfview in mirror mode, e.g. the selfview is reversed and the experience of
selfview is as seeing yourself in a mirror.
Off: See the selfview in normal mode, e.g. the experience of selfview is as seeing yourself as
other people see you.
Example: Cameras Camera 1 Mirror: Off
CamerasCamera[1..1]WhitebalanceMode
Set the camera whitebalance mode.
Requiresuserrole: ADMIN
Valuespace: <Auto/Manual>
Auto: The camera will continuously adjust the whitebalance depending on the camera view.
Manual: Enables manual control of the camera whitebalance, e.g. the level of the
whitebalance level setting will be used for the camera.
Example: Cameras Camera 1 Whitebalance Mode: Auto
CamerasCamera[1..1]WhitebalanceLevel
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to manual.
Requiresuserrole: ADMIN
Valuespace: <1..16>
Range: Select a value from 1 to 16.
Example: Cameras Camera 1 Whitebalance Level: 1
CamerasCamera[1..1]DHCP
Applies to cameras which support DHCP. The Cisco TelePresence PrecsisionHD 1080p camera
supports DHCP. The camera must be connected to a LAN. When set, the command enables
support for SW upgrade of daisy chained cameras. It will enable the camera's DHCP function
and force start of MAC and IP address retrieval. Remember to reset the DHCP when the camera
is no longer connected to a LAN.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the
DHCP is started and the IP address will be retrieved. Run the commnand "xStatus Camera"
for result.
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is
not connected to a LAN.
Example: Cameras Camera 1 DHCP: Off
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings
 previous next