Cisco Systems CTSSX20PHD12XK9 Security Camera User Manual


  Open as PDF
of 80
 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
57
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
TheSystemUnitsettings
SystemUnitName
Enter a System Name to define a name of the system unit. If the H.323 Alias ID is configured
on the system then this ID will be used instead of the system name. The system name will be
displayed:
1) When the codec is acting as an SNMP Agent.
2) Towards a DHCP server.
Requiresuserrole: ADMIN
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: SystemUnit Name: "Meeting Room"
SystemUnitMenuLanguage
Select the language to be used in the menus on screen.
Requiresuserrole: USER
Valuespace: <English/ChineseSimplified/ChineseTraditional/Czech/Danish/
Dutch/Finnish/French/German/Hungarian/Italian/Japanese/Korean/Norwegian/
Polish/PortugueseBrazilian/Russian/Spanish/SpanishLatin/Swedish/Turkish>
Example: SystemUnit MenuLanguage: English
SystemUnitContactInfoType
Describes which parameter to put in the status field in the upper left corner on the screen
display. The information can also be read with the command xStatus SystemUnit ContactInfo.
Requiresuserrole: ADMIN
Valuespace: <Auto/None/IPv4/IPv6/H323Id/E164Alias/SipUri/SystemName>
Auto: Shows the address which another system can dial to reach this system, depending on
the default call protocol and system registration.
None: Do not show any contact information.
IPv4: Shows the IPv4 address as the contact information.
IPv6: Shows the IPv6 address as the contact information.
H323Id: Shows the H323 ID as the contact information.
E164Alias: Shows the H323 E164 Alias as the contact information.
SipUri: Shows the SIP URI as the contact information.
SystemName: Shows the system name as the contact information.
Example: SystemUnit ContactInfo Type: Auto
SystemUnitCallLoggingMode
Set the call logging mode for calls that are received or placed by the system. The call logs may
then be viewed via the web interface or using the xHistory command.
Requiresuserrole: ADMIN
Valuespace: <On/Off>
On: Enable logging.
Off: Disable logging.
Example: SystemUnit CallLogging Mode: On
SystemUnitIrSensor
Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them
needs to be enabled at the time. The IR sensor LED is located on the front of the codec and the
camera and flickers when an IR signal is received from the remote control.
Requiresuserrole: ADMIN
Valuespace: <On/Off/Auto>
On: Enable the IR sensor on the codec.
Off: Disable the IR sensor on the codec.
Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at
camera is enabled. Otherwise, the IR sensor on the codec will be enabled.
Example: SystemUnit IrSensor: Auto
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings
 previous next