Cisco Systems CTSSX20PHD12XK9 Security Camera User Manual


 
D14908.01 SX20 Administrator Guide (TC5.1) | 2012 FEBRUARY | © 2012 Cisco Systems, Inc. All rights reserved. www.cisco.com
44
Cisco TelePresence SX20 Quick Set
ADMINISTRATOR GUIDE
Network[1..1]VLANVoiceMode
Set the VLAN voice mode.
Requiresuserrole: ADMIN
Valuespace: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If
CDP is not available, VLAN is not enabled. The VLAN Voice Mode automatically will be set to
Auto when the GUI is used to set the Provisioning Mode to CUCM.
Manual: The VLAN id is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Example: Network 1 VLAN Voice Mode: Off
Network[1..1]VLANVoiceVlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requiresuserrole: ADMIN
Valuespace: <1..4094>
Range: Select a value from 1 to 4094.
Example: Network 1 VLAN Voice VlanId: 1
Introduction
Table of contents
Web interface
Advanced settings
Appendices
Advanced settings